D. Plug the power adaptor into the power line outlet.
E. On power-up , the PCR21X shou1d produce
“
BEEP "sound and
the Status LED on PCR212 will
illuminate GREEN to be ready to
read or the LCD on PCR2lO will turn on to be ready to read .
To check the device functioning, you will need to use some terminal software. The term “terminal” refers
to the ability of the software to send, receive and display the data that is being transmitted through the
serial COM port of your computer. There are dozens of suitable programs on the market, such as
QMODEM or TELIX or PROCOMM for MS DOS.
However, one program called “HyperTerminal” is very common and comes as a part of Windows-95.
This HyperTerminal can be found in the “Accessories” folder of the “Programs” group of the “Start”
menu.
Note: The explanation below assumes that you have a basic knowledgement of Windows-95.
To test the PCR2lX functioning:
Launch the HyperTerminal.
On start-up, the Dialog box will be displayed, requesting you to type in the name of your
connection .You can give my name, for instance: TEST.
The next Dialog box will ask for telephone number. This is because the HyperTerminal also works
with modems. In your case, the telephone number is not applicable, so you don’t have to enter it .Just
select the appropriate COM port from the ‘Connect using’ drop-down list. For example, if your
PCR2lX is attached to the COM2, you should select ‘Direct to COM2’.
The next Dialog box will prompt for port settings. Here is what you should choose:
Bits per second
9600 if you select 9600 baud on PCR
Data bits
8
Parity
None
Stop
bits
1
Flow
control
None
After this Dialog closes, the program is finally satisfied and the terminal screen is displayed.
Now you may try to read the proximity cards .Get a RFID card to be close to the PCR2lX unit, the
PCR21X will produce a short beep, thus indicating that the read was successful, and you should see
the registration number of the RFID card printed in the terminal window.
Note: In order to avoid multiply reading data, PCR2lX only can read the same card once when it is put within
the reading distance. So you must move the card out of the reading distance and then put it back within
the reading distance, the PCR2lX then can read the card again.
PCR210 is equipped with a Brightness Control on the back of the unit to adjust the displaying quality
of the LCD.
4.DIP SWFITCH BLOCK SETTENGS
The DIP Switch Block is located on the bottom of the unit.
The Switch Block contains switches numbered 1-8.These switches must be set while the power is off to
ensure that the switch settings are properly loaded.
Switch l & 2: To select Baud Rates
SW1
SW2
Baud Rate
