6
Gigaset L410 / en-USA / A31008-M2240-R301-2-UL19 / archimedes_en.fm / 14.03.2012
V
e
rsion
1, 1
4
.03.20
12
Registration failed
u
A negative confirmation tone is emitted (sequence of tones falling in pitch).
u
If the device cannot be registered within 5 minutes, it switches off.
If the registration was not successful, try again.
¤
If necessary, switch on the device again. It is immediately ready for registration.
¤
Check whether the registration PIN on the base is set to 0000.
¤
Move closer to the base with the Gigaset L410.
If the device is already registered to another base, you must de-register it
(
page 10). Following this, it will be ready for registration again.
Charging the battery
When delivered, the battery is partly charged. When the device is registered and
on stand-by, the charge status is shown as follows:
In all other operating conditions, (
page 2) the charge status is not displayed by
means of the LED.
When the battery is almost empty, a signal tone is always emitted, 1 x per min.
Securing the clip
¤
Attach the Gigaset L410 to
your clothing using the clip.
Optimal distance from your
mouth: 20 cm
Device
Battery status
LED
In the charging cradle
Fully charged
Steady green light.
Charging
Steady red light.
Not in the charging
cradle
Sufficient charge
Flashes green, every 5 seconds
Almost empty
Flashes red, every 5 seconds
To charge the battery:
¤
Connect the charging cradle to the mains
power and place the device in the charging
cradle .
It will be fully charged within
2.5 hours
. You can
interrupt the charging procedure.
Note:
If you place the device in the charging cradle
during a call, this will not disconnect the call.