Gigaset AS690HX / LHSG AU en / A31008-M2870-C401-1-7619 / appendix_HX.fm / 1/21/21
Te
mplat
e
M
odu
le
, V
e
rs
ion 2.
1,
1
1
.08.
20
20
/
Te
mpl
a
te Basiseinstellu
ngen:
V
e
rsio
n 3.
1
-
0
7
.0
7
.20
20
Manufacturer‘s advice
Availability and operation of the functions
may differ on your telephone.
41
Environmental management system
Gigaset Communications GmbH is certified pursuant to the international standards ISO 14001 and
ISO 9001.
ISO 14001 (Environment):
Certified since September 2007 by TÜV SÜD Management Service
GmbH.
ISO 9001 (Quality):
Certified since 17/02/1994 by TÜV SÜD Management Service GmbH.
Disposal
Batteries should not be disposed of in general household waste. Observe the local waste disposal regulations,
details of which can be obtained from your local authority.
All electrical and electronic equipment must be disposed of separately from general household waste using
the sites designated by local authorities.
The appropriate disposal and separate collection of used equipment serve to prevent potential
harm to the environment and to health. They are a precondition for the re-use and recycling of
used electrical and electronic equipment.
For further information on disposing of your used equipment, please contact your local authority
or your refuse collection service.
Care
Wipe the device with a
damp
cloth or an antistatic cloth. Do not use solvents or microfibre cloths.
Never
use a dry cloth; this can cause static.
In rare cases, contact with chemical substances can cause changes to the device’s exterior. Due to the wide
variety of chemical products available on the market, it was not possible to test all substances.
Impairments in high-gloss finishes can be carefully removed using display polishes for mobile phones.
Contact with liquid
Your handset is splash proof.
If it comes into contact with water, knock the water out of the microphone opening and remove any water on
the handset with an absorbent cloth. Your handset is ready for use.
If your handset comes into contact with a larger amount of liquid take the following steps:
1
Unplug all cables from the device.
2
Remove the batteries and leave the battery compartment open.
3
Allow the liquid to drain from the device.
4
Dab all parts dry.
5
Place the device in a dry, warm place
for at least 72 hours
(
not
in a microwave, oven etc.) with the battery
compartment open and the keypad facing down (if applicable).
6
Do not switch on the device again until it is completely dry.
When it has fully dried out, you will normally be able to use it again.