Chapter 3 Appendix
Before you begin, please prepare the following items:
•
At least two SATA hard drives or SSDs.
(Note 1)
(To ensure optimal performance, it is recommended that you
use two hard drives with identical model and capacity).
(Note 2)
•
Windows setup disk.
•
Motherboard driver disk.
•
A USB thumb drive.
Coniguring the Onboard SATA Controller
A. Installing SATA hard drive(s) in your computer
Install the hard drives/SSDs in the Intel
®
Chipset controlled connectors on the motherboard. Then connect the
power connectors from your power supply to the hard drives.
B. Coniguring SATA controller mode in BIOS Setup
Make sure to conigure the SATA controller mode correctly in system BIOS Setup.
Steps:
1. Go to
Peripherals\SATA And RST Coniguration
, make sure
SATA Controller(s)
is enabled. To create
RAID, set
SATA Mode Selection
to
Intel RST Premium With Intel Optane System Acceleration
. Then
save the settings and restart your computer. Note: When using a PCIe SSD, make sure to set the
Use RST
Legacy OROM
item under
Peripherals\SATA And RST Coniguration
to
Disabled
. Then depending the
M.2 connector you use, set the corresponding
PCIe Storage Dev On Port XX
item to
RST Controlled
.
2.
To use the EZ RAID feature, follow the steps in "C-1." To conigure UEFI RAID, follow the steps in "C-2." To
enter the legacy RAID ROM, refer to "C-3" for more information. Finally, save the settings and exit BIOS Setup.
3-1 Coniguring a RAID Set
RAID Levels
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
(Note 1) An M.2 PCIe SSD cannot be used to set up a RAID set either with an M.2 SATA SSD or a SATA hard
drive.
(Note 2) Refer to "1-7 Internal Connectors," for the installation notices for the M.2 and SATA connectors.
C-1. Using EZ RAID
GIGABYTE motherboards provide you with the EZ RAID feature, allowing you to quickly conigure a RAID
array with simpliied steps.
Steps:
1. After restarting the computer, enter the BIOS Setup and go to
Peripherals
. Press <Enter> on the
EZ RAID
item. Select the type of hard drives you use for RAID in the
Type
tab and then press <Enter>.
2. Go to the
Mode
tab to select a RAID level. RAID levels supported include RAID 0, RAID 1, RAID 10, and
RAID 5 (the selections available depend on the number of the hard drives being installed). Then press
<Enter> to move to the
Create
tab. Click
Proceed
to begin.
RAID 0
RAID 1
RAID 5
RAID 10
Minimum
Number of Hard
Drives
≥2
2
≥3
4
Array Capacity
Number of hard
drives * Size of the
smallest drive
Size of the smallest
drive
(Number of hard
drives -1) * Size of
the smallest drive
(Number of hard
drives/2) * Size of the
smallest drive
Fault Tolerance
No
Yes
Yes
Yes
- 39 -
Содержание Z390 UD
Страница 46: ... 46 ...
Страница 47: ... 47 ...
