BIOS Setup
50
•
Boot Sector Virus Protection
If it is set to enable, the category will flash on the screen when there is any attempt to write to
the boot sector or partition table of the hard disk drive. The system will halt and the following
error message will appear in the mean time. You can run anti-virus program to locate the
problem.
Enabled
Activate automatically when the system boots up causing a warning
message to appear when anything attempts to access the boot sector or
hard disk partition table
Disabled
No warning message to appear when anything attempts to access the boot
sector or hard disk partition table
(Default Value)
•
Memory
The category is display-only which is determined by POST (Power On Self Test) of the BIOS.
Base Memory
The POST of the BIOS will determine the amount of base (or conventional)
memory installed in the system.
The value of the base memory is typically 512 K for systems with 512 K memory
installed on the motherboard, or 640 K for systems with 640 K or more memory
installed on the motherboard.
Other
Memory
This refers to the memory located in the 640 K to 1024 K address space. This is
memory that can be used for different applications.
DOS uses this area to load device drivers to keep as much base memory free for
application programs. Most use for this area is Shadow RAM.
Extended Memory
The BIOS determines how much extended memory is present during the POST.
This is the amount of memory located above 1 MB in the CPU's memory address
map.
Содержание 6CMC7 Series
