Gibson 2010 Les Paul Standard LTD ED, Руководство пользователя

Страница: 26 / 37

Gibson LP STD LTD Manual v1.0 Page 26
The setup menu allows access to setup parameters and functions that control the system behavior.
6.0 Entering Function Mode
●
If Les Paul Standard 2010 Limited is not powered ‐ up, pull the MCK out and push Enter four
times briefly, in quick succession. Each press must be within a half ‐ second of the previous press.
●
If Les Paul Standard 2010 Limited is already in a Bank other than the Red Bank, push Enter
briefly in quick succession until the Red Bank appears.
6.1 Selecting Setup Mode
1. Once Les Paul Standard 2010 Limited is in the Red Bank, rotate the MCK fully counter ‐
clockwise to the b# position. The Display Matrix shows a filled ‐ in circle.
2. Push Enter for longer than one second; the Display Matrix shows a while “enter” symbol (an
arrow with a right ‐ angle tail).
3. Push Enter again for longer than one second. The Display Matrix now shows a cyan enter
symbol
4. To change a setup parameter, you first need to enter its ID number, and then the value. Enter
ID numbers sequentially by turning the MCK to the first digit and pushing Enter briefly. If the ID
number has two digits, rotate the MCK to the next digit and push Enter briefly. If the ID number
has three digits, rotate the MCK again to the third digit, and push Enter briefly. When you press
Enter after selecting a digit, the number in the Display Matrix flashes red briefly for
confirmation.
5. After entering the ID number, turn the MCK fully counterclockwise to the Enter position
(cyan arrow with right ‐ angle tail) and push Enter briefly. The MCK will show the entered ID
number, then a question mark to indicate that you can now enter the parameter value.
6. Enter the parameter value the same way as you entered the setup function ID: Rotate the
MCK to the desired number, and push Enter briefly (repeat for multi ‐ digit values). After pushing
Enter, the number in the Display Matrix will flash red for confirmation.
7. After entering the value, turn the MCK fully counter ‐ clockwise to the Enter position (cyan
arrow with right ‐ angle tail) and push Enter briefly. The Display Matrix will show the entered
parameter value, then flash all outer LEDs green to confirm that the value has been accepted.
8. Exit the Setup menu by pushing Enter for more than one second.
The following set of tables shows the various user ‐ editable Functions available in Function Mode, but
please notes the following important points.
Note 1: The function's “clickstream” shown in each chart abbreviates the MCK operations needed to
edit the function. To save space and text:
●
It's assumed you've already completed steps 1 ‐ 3 under Selecting Setup Mode.
●
The § symbol means, “rotate the MCK fully counter ‐ clockwise then push Enter briefly.”