NOTE!
Avoid scratching or damaging the integrated seatpost during the installation
of the Cutting Guide.
NOTE!
Do not attempt to clamp ISP frame into a traditional work stand and by either
the ISP or the top tube. Doing so will cause failure and void the warranty.
STEP4.
Put the seat tube in a horizontal position. Use the Cutting Guide to guide the
hacksaw blade to achieve a straight, perpendicular cut (as per Park Tool's
instructions).
NOTE!
To avoid fraying the
composite fibers. Use a fine tooth
(32 tooth) saw blade.
NOTE!
Be sure to wear appropriate
safety equipment, such as glasses,
gloves and a dust mask. Make sure
not to inhale any of the dust!
NOTE!
Take care when finishing
the cutting process to not splinter
the composite.
STEP5.
Carefully sand-down any burrs with fine emery paper.
STEP6.
Remove the Cutting Guide from the integrated seatpost. Then, install the saddle
onto the seatpost and rechecking the Target Saddle Height.
If the SADDLE HEIGHT is still lower than the target (or when you want to fine tune
saddle height in the future), you should use the included ISP seat clamp spacers to
add the saddle height.
NOTE!
If the end of the integrated seat post is not touching the base of the seat
clamp structure, the integrated seatpost may break and result in a serious accident.
