
www.giadatech.com
www.giadatech.com
www.giadatech.com
www.giadatech.com
8.ATX1
9.Mini_PCIe
10.J3
11.USB3
12.SYS_FAN
13.SATA_PWR
17.COM2/COM3
18.J1
20.LVDS
21. HD1
22.ANT1
23.J9
19.IR-HD1
14.ANT2
15.SATA
16.J5
(ATX Power)
(Only used for 3G module)
(USB2.0)
(2 pin SYS_FAN)
(SATA Power ,Max 12V)
( COM2 only supports Tx/Rx,CTS/RTS 4-wire communication;COM3 only supports Tx/Rx 2-wire
communication)
(default 1920*1080,5V power supply,Max 12V)
LVDS panel backlight control
interface, can fit in both 6-pin
socket. Output voltage is equal to
DC_IN voltage.
Default support for Dual channel 8bit, maximum resolution of 1920 x 1080, LVDS_PWR supply Min
3.3V ,Max 12V), default 5V power supply. Need to set HD1 jumper to adjust LVDS_PWR according
to LCD panel parameters.
(LVDS power supply jumper,default 5V)
LVDS_PWR supply jumper,Default 5V,
(Wi-Fi/Bluetooth Antenna Port)
(The front panel function interface)
(Infrared receiver connected pin)
(GPS Antenna Port.Need 3.3V GPS Active Antenna)
(2.5' SATA HDD)
3W
Jumper 1-2 put ON
5W
umper 1-2 take OFF
1 LVDS_PWR
2 LVDS_PWR
3 LVDS_PWR
4 GND
5 GND(Default) or SDA
6 GND(Default) or SCL
7 LVDSO_DN0
8 LVDSO_DP0
9 LVDSO_DN1
10 LVDSO_DP1
11 LVDSO_DN2
12 LVDSO_DP2
13 GND
14 GND
15 LVDSO_CLKN
16 LVDSO_CLKP
17 LVDSO_DN3
18 LVDSO_DP3
19 LVDSE_DN2
20 LVDSE_DP0
21 LVDSE_DN1
22 LVDSE_DP1
23 LVDSE_DN0
24 LVDSE_DP2
25 GND
26 GND
27 LVDSE_CLKN
28 LVDSE_CLKP
29 LVDSE_DN3
30 LVDSE_DP3
Pin1-2
3.3V power supply output
Pin3-4
5V power supply output
Pin5-6
12V power supply output
1 power signal (3.5~5V/50mA power)
2 power LED signal(5V 5mA)
3 state LED signal(3.3V 3mA)
4 power key signal(Internal week pull-up,Low Active)
5 GND
6 system reset signal ((Internal week pull-up ,Low Active)
(Only used for
IR burning.
Don’t use it without
special guidance
from Giada)