Pub. 42004-432E
Model 370-400 UHF and 370-420 VHF Page/Party® Radio Couplers
Page 4 of 10
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-432E.docx
05/18
Mounting the Enclosure
1.
Mount the enclosure using the four 0.312-inch (8
mm) diameter holes located on the mounting
flanges with ¼-inch (M6) hardware. The
Page/Party
®
Radio Coupler is not supplied with
conduit or cable openings.
2.
Remove the front panel and drill or punch entry
openings in the rear section of the enclosure (see
Figure 2 for suggested locations).
There must be a minimum of ½ inch (13 mm) of
material between entry holes. GAI-Tronics
recommends bottom entry only wherever
possible.
The standard mounting orientation (see Figure 2),
locates the power supply housing in the upper left
corner. The orientation of the enclosure can be
rotated 180º to allow clear access to the top. When
mounting the enclosure, use caution to avoid
damaging the internal components.
Antenna Installation
Select an appropriate antenna based upon the
frequency of the radio and connect it to the BNC
connector on the top of the enclosure (see Figure 3).
The antenna should be remotely mounted in a location
that provides line-of-sight communication to the
surrounding area. Refer to the Specifications section
for specific RF module frequency information.
Figure 2. Mounting Details and Wire Entry
Locations
Figure 3. Antenna Connection
