AXWV WIRELESS VEHICLE SENSOR
OVERVIEW
Wireless Vehicle Sensor
Control Unit
Minimum of 20 Feet
Maximum of 100 Feet
from control board
sensor cable
WARNING: This product can expose you
to chemicals including lead, which is known
to the State of California to cause cancer.
For more information, go to
www.P65Warnings.ca.gov
WARNING: DO NOT USE THIS DEVICE WITH LIVESTOCK OR OTHER ANIMALS.
NOTE
THIS VEHICLE SENSOR ONLY WORKS WITH GHOST CONTROLS OPENER SYSTEMS.
PLEASE READ THE INSTRUCTIONS INCLUDED WITH THIS ITEM PRIOR TO INSTALLING.
IMPORTANT ITEMS REQUIRED
Two (2) C Alkaline Batteries are required and
not included. One (1) Ghost Controls Transmitter that already operates the gate.
KIT CONTENTS:
■
1 – Control Unit with control board (to be installed above ground)
■
1 – Sensor Probe with 10 foot cable (to be buried below ground)
■
1 – 12
"
PVC Pipe
PREPARING FOR INSTALLATION:
■
Must be located at least 20 feet beyond the path of the moving gate.
■
Must be located where the driver of the approaching vehicle has clear view of the gate.
■
Bury probe approximately 12
"
deep and as close to the driveway as possible for maximum detection of moving vehicles.
■
The Control Unit must be at least 6
"
above ground.
■
The Control Unit also should be with 100 feet of the Ghost Controls receiver/control box.
NOTE
The operating distance may vary depending on Radio Frequency interference at each installation site. Avoid installing the unit near
power lines, transformers or running motors.
PVC Pipe
Control Unit
Sensor Probe
Control Unit Cover
