S99_0_25_6C-03
Configuration manual LAN 3200, WLAN 3200
Seite 3 von 4
_____________________________________________________
_____________________________________________________________________________
A.4
This device must not be used at potentially explosive areas! The usage of this
device at potentially explosive areas increases danger of deflagration, explosion or
fire due sparking.
A.5
Do not use this product as safety or emergency stop device or in any other
application where failure of the product could result in personal injury or material
damage.
Failure to comply with these instructions could result in death or serious injury and
material damage.
A.8
Only use the shipped power supply for this device.
B.1
When transporting the device from a colder to a warmer ambience condensation
may cause a malfunction. In that case, before operating, it is needed to wait until the
device temperature has aligned to the ambience.
B.3
The conceptual design, particularly when connecting with other devices has to be
done thoroughly.
Internal connections of other devices (e.g. from ground with protective earth)
may lead to prohibited voltage levels that could disturb the function, damage or
even destruct the device or any connected equipment.
Never run the device with a damaged or faulty power supply.
Risk of death by electrocution!
C.5
Whenever there may be a risk whatsoever involved in running it, the device has to be
switched off immediately and to be marked accordingly to avoid re-starting. Operator
safety may be a risk if:
- there is visible damage to the device
- the device is not working as specified
- the device has been stored under unsuitable conditions for a longer time
In case of doubt, please return device to manufacturer for repair or maintenance (with
costs).
3 Product description
3.1 Scope of supply
LAN 3200, WLAN 3200 with power supply
Manual
USB adapter
CD with freeware and drivers (GHM Messtechnik GmbH
– Site GREISINGER)
CD with drivers (LAN 3200, WLAN 3200)
CD with drivers (USB adapter)
3.2 Operating and maintenance
1.
Treat device and sensor carefully. Use only in accordance with above specification.
(Do not throw, hit against etc.). Protect plug and socket from soiling.
2.
Supply connection / Mains operation:
When connecting a mains cable, please take care to connect only allowed
components. Carefully check the polarity and the correct connection.
Don’t apply overvoltage!
3.
The device contains no serviceable parts inside. In case of errors or malfunction
please return device to manufacturer for repair or maintenance (with costs).
4 Driver installation and configuration
4.1 Device configuration
The IP address will be assigned through DHCP. After the valid DHCP process the device is available in the
LAN. The drivers will automatically find all devices connected to the LAN with valid IP addresses.
When a static IP is desired, the tool
“
Device Server Setup
” from the drivers CD has to be run. Here the
static IP address can be assigned.
