Instruction Manual
Mitras LX7
EN
2016-12-27
14
TIP
Master and Slave modes are ideal for running simulations across all
luminaires. These simulations can be performed across one or more
luminaire:
Gliding cloud simulation
Sunrise and sunset with east-west simulation
Thunderstorm
It is particularly convenient to use these settings via the
GHL Control Center
(See below 6.2)
Set the time and date first.
TIP
If several
Mitras® LX7
are operated, it is sufficient to make the settings for
the lighting and the clock with only one luminaire
.
Set this luminaire as a master (Menu: System-> Wireless), the others as
slaves, and give the luminaires different addresses (Nos.1-31).
The settings of the master light are then transmitted via radio to the other
luminaires.
Press any arrow key to enter. You can move up and down from the right to the left with the
arrow keys in the menu. The right and left arrow keys are programmed as shortcut keys. You
can press the buttons to go directly to thunderstorm or maintenance.
The operation of the device is very simple. Use the up and down arrow keys to navigate
through the menus and make a selection.
To confirm the selection of a menu item, press the confirmation key (Check mark button:
Confirm input =
Return
). This will take you to the sub-menus.
Make the desired changes and save them with the confirmation key. Press the Cancel key
(Cross mark button: Cancel input =
Escape
) to abort entries.
After each setting process, you are asked if you want to save the changed settings. Only after
confirmation with Yes, the new settings are accepted and saved. These settings are also
stored in the nonvolatile memory (EEPROM, independent of the mains voltage) and are
restored after voltage interruption.
