3M VHB
TAPE
WALL
CORRECTION
FOAM
THIS END
ATTACHES
TO HEX
THIS END
ATTACHES
TO WALL
STEP 11
STEP 12
STEP 13
Place a thumb tack into the top of the
center view finder.
Level out the Hex hanger and mark the
center of your mounting holes.
Fasten two screws in through the Hex
hanger via the mounting holes.
Note: The mounting holes are square to
allow for the maximum amount of
adjustment.
Note: Repeat steps 5-13 for the remaining
Hex hangers.
IS-HEX 7/16/14
Watch the installtion video here: www.ghent.com/hex
Wall Correction Device:
If your wall is not flat, and is pushing out
the bottom of your Hex, we have included
a wall correction device. To install this,
simply remove the tape cover on both
sides of the foam. Attach the foam to the
bottom edge on the back of the Hex, then
attach the foam to the wall. This will
correct any wall defects.
(NOTE: This is a permanent solution and
should only be applied when Hex installation
is complete.)
3M DUAL
LOCK
3
