11
8. Options
8.1 Electric foot switch
An additional foot switch to adjust the inclination is optional available (RLX
ELECTRIC only). Use the relevant switch to adjust the inclination of the lying
surface.
8.2 Heater Smart Thermo II
The lying surface of RLX can be heated to maximize the treatment comfort. You
can set 10 heating levels using the HCP. For quick heating of a cold lying surface,
after starting the heater will operate with max. power during the pre-heating period.
The parameters of the heater can be programmed and saved if desired. Check the
current temperature before using the RLX. Disconnect RLX from the mains when
it is not used for a longer period of time, e.g. during the night.
HCP
8.2.1 Heater control panel (HCP)
You can operate the heater using the 4 buttons ON/OFF/+/-.The setting of the
heating power is indicated by a 10-level LED bar-diagram. The green LEDs 1-4
indicate low power/low temperatures. The yellow LEDs 5-7 indicate medium
power/medium temperatures. The red LEDs 8-10 indicate high power/high
temperatures.
8.2.2 Heating
Switch on the heater using the ON-button on the control panel. The preheating
period starts on highest setting. After the pre-heating time has elapsed, the normal
treatment setting will start. You can stop the pre-heating period using the + and -
