GGP ITALY SPA Portable Hedge Trimmer, Руководство оператора

Страница: 17 / 19

PRESERVATION
After each working session, carefully clean the
machine from dust and debris, repair or replace
any faulty parts and lubricate the blades to pre-
vent them from rusting.
The machine must be preserved in a dry area,
protected from all weather conditions and with
the blade protection device correctly fitted.
PROLONGED IDLE PERIODS
If the machine will not be
used for a period of more than 2-3 months it is
recommended to follow some advice to avoid
difficulty when you wish to use the machine and
to prevent permanent damage to the engine.
• Storage
Before storing the machine:
– Empty the fuel tank.
IMPORTANT
– Start the engine and allow it to tick over until it
comes to a halt, so that it uses all the fuel that
is left in the carburettor.
– Allow the engine to cool down and remove the
spark plug.
– Pour a a teaspoon of (new) 2-stroke engine oil
into the spark plug slot.
– Pull the starter wire a couple of times to dis-
tribuite the oil in the cylinder.
– Replace the spark plug with the piston in the
dead end upper position (visibile from the
spark plug slot when the piston is at maximum
stroke).
• Restarting work
When you wish to start using the machine again:
– Remove the spark plug.
– Pull the starter wire a couple of times to elim-
inate all excess oil.
– Check the spark plug as described in chapter
“Checking the spark plug”.
– Prepare the machine as indicated in the para-
graph entitled “Preparing for work”.
30 MAINTENANCE AND PRESERVATION / IDENTIFICATION OF FAULTS
EN
8. IDENTIFICATION OF FAULTSI
PROBLEM LIKELY CAUSE SOLUTION
1) The engine will
not start or will not
keep running
2) The engine starts
but is lacking in
power
3) The engine runs
irregularly and lacks
in power when
revved
4) The engine gives
off an excessive
amount of smoke
– Incorrect starting procedure
– Dirty spark plug or incorrect distance
between the electrodes
– Air filter clogged
– Carburation problems
– Air filter clogged
– Carburation problems
– Dirty spark plug or incorrect distance
between the electrodes
– Carburation problems
– Incorrect composition of the fuel mix
– Carburation problems
– Follow the instructions (see chap.
5)
– Check the spark plug (see chap.
7)
– Clean and/or replace the filter
(see chap. 7)
– Contact your Retailer
– Clean and/or replace the filter
(see chap. 7)
– Contact your Retailer
– Check the spark plug (see chap.
7)
– Contact your Retailer
– Prepare the fuel mix according to
the instructions (see chap. 4)
– Contact your Retailer