·
If you turn it clockwise, the time gets longer.
·
When you are changing the setting, use accurate cross screwdriver.
·
In factory condition, it is set at the shortet time possible.
※ Contact your vendor or our second factory if you haveany questions about
product or requirepost-sales service.
Leader of geared motor GGM CO.,LTD.
http://www.ggm.co.kr
Headquarters / 1st Factory
22, Gyeongin-ro 3beon-gil, Bucheon-si,
Gyeonggi-do, Republic of Korea
TEL : 82-32-664-7790 FAX : 82-32-611-7791
Attached research institute / No. 2 factory
180, Oksan-ro, Bucheon-si, Gyeonggi-do,
Republic of Korea
TEL : 82-32-684-7791 FAX : 82-32-683-5059
LED flickering
·
If torque that is greater that the rating is applied to the motor for motor
for more than 5 seconds or if the motor rotation direction changes quickly
or turns on/off.
LED on
·
If there is a problem with motor feedback signal due to motor cable
disconnection and connector connection problem
·
If load is being carried downwards or too much load is operated on
8-2. Alarm output
In the following case, control unit protection function gets turned on and
alarm out gets also turned on (L-LEVEL). Then, the motor stops. In this
case,it is shown with LED light on or off. Check the protection details.
※ When you are providing power, if the LED light turns on instantaneously,
that is not a sign of malfunctioning.
Item
Hall sensor alarm
Over load alarm
Over heat alarm
Over voltage alarm
Over current alarm
Normality
LED sign
Flickering 1 times at 6 seconds intervals (Red)
Flickering 3 times at 6 seconds intervals (Red)
Flickering 5 times at 6 seconds intervals (Red)
Flickering 6 times at 6 seconds intervals (Red)
Flickering 8 times at 6 seconds intervals (Red)
Green light on ( Power )
Note
Motor stop
9-1. Slow start
9. Acceleration / Deceleration control
Motor response speed can be set between 0.5~10 seconds (at 3000rpm)
9-2. Slow stop
If you are stopping motor from outside, you can set the motor stopping
time time at 0.5-10 seconds (at 3000rpm)
·
When you extend input/output signal cable, do it for less than 2m. Try
to make it as short as possible to minimize noise.
·
input/output signal cable should be separated from power cable and
motor cable.
When you access by following the direction above, alarm output will be
off when control unit is (H-LEVEL) and on when control unit is(L-LEVEL),
stop the motor and turn off the control unit.
If there is no problem with motor cable, check other use conditions (load
torque, operation pattern and power voltage) Remove the reasons of
protection mode and reapply power to reset alarm output
10. How to install communication module
Open the control case
Switch change
Install 485 communication module
1. Please release the lock point
on the side of the product
and slide the case to
separate it.
2. Change the switch to right.
3. Install the communication
module in opposite side.
1
2
3
