06
WARNING AND SAFETY NOTES
07
G6P
G6P
These warnings and safety notes are particularly important. Please
follow the instructions for maximum safety; otherwise the charger and
the battery can be damaged or at worst it can cause a fire.
The
allowable
DC input
voltage
is 11-18V
DC
.
The
allowable
AC input
voltage
is
100-240V AC
.
Never leave the charger unattended when it is connected to its
power supply. If any malfunction is found, TERMINATE THE
PROCESS AT ONCE and refer to the operation manual.
Keep the charger well away from dust, damp, rain, heat, direct
sunshine and vibration. Never drop it.
This charger and the battery should be put on a heat-resistant,
non-flammable and non-conductive surface. Never place them on
a car seat, carpet or similar surface. Keep all flammable volatile
materials away from the operating area.
Make sure you know the specifications of the battery to be
charged or discharged to ensure it meets the requirements of this
charger. If the program is set up incorrectly, the battery and
charger may be damaged. Fire or explosion can occur due to
overcharging. This warranty is not valid for any damage or
subsequent damage arising as a result of a misuse or failure to
observe the procedures outlined in this manual.
To avoid short circuiting between the charge lead, always connect
the charge cable to the charger first, then connect the battery.
Reverse the sequence when disconnecting.
Never
attempt
to
charge
or
discharge
the
following
types
of
batteries
:
A battery fitted with an integral charge circuit or a protection circuit
A battery pack which consists of different types of cells
(including different manufacturers)
A battery that is already fully charged or just slightly discharged
Non-rechargeable batteries (pose an explosion hazard)
A faulty or damaged battery
WARNING AND SAFETY NOTES
Batteries installed in a device or which are electrically linked to
other components
Batteries that are not expressly stated by the manufacturer to
be suitable for the currents the charger delivers during the
charge process
Never attempt to charge or discharge non-rechargeable
batteries.
During charging, the battery must be placed in a well ventilated
area (for chargers for lead-acid batteries)
The battery charger must only be plugged into an earthed
socket-outlet (for portable class I battery chargers for outdoor
use)
In “Auto” charging mode for NiMH/NiCd battery with low
impedance and capacity, users could set up the upper limit of
the charging current.
Never place the charger and batteries connected to it on any
form of flammable surface. Never operate the charger in the
vicinity of inflammable material or gas.
Take great care to maintain correct battery polarity and avoid
short-circuit. Read the battery manufacturer’s instructions and
adhere to them strictly.
This appliance is not intended to use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
If the supply cord is damaged, it must be replaced by a special
cord or assembly available from the manufacturer or its service
agent.
