Operating instructions GF 500
7 Fusion
15
7.2.3
Adjusting of the fusion pressure
1.
Open the machine.
2.
Reduce pressure with the fine-adjustment pressure valve (turn
counter-clockwise).
3.
Move control lever towards “close ><” position and increase
pressure on the pressure valve (turn clockwise) until clamping
carriage moves smoothly.
4.
Adjust fusion pressure with the fine adjustment pressure valve as soon
as both pipe ends are in contact (turn clockwise).
If the fusion pressure is set too high, re-adjust:
1.
Open the machine.
2.
Turn the fine-adjustment pressure valve approx. 3 revolutions to the
left.
3.
Start fusion pressure again and set as described above.
7.2.4
Preparing the fusion surfaces
Danger of cutting hands!
Sharp planer blades!
Danger of injury to hands if the planer disk is touched.
:
Do not touch the rotating planer disk.
X
Snap in the safety lock.
"Emergency Stop" function!
By pressing the "Emergency Stop" button, power to the planer motor is
immediately interrupted. The planer motor can be started by pressing
the black toggle switch.
1.
Open the machine.
2.
Insert planer.
3.
Snap in the safety lock.
This prevents the planer unit from jumping out of the machine during
planing
.
Warning
Important
