GEZE Powerturn, Инструкция по установке и обслуживанию

Страница: 13 / 56

Powerturn
13
Preparing installation
6.1.1 Preparations to be made on site
Checking of the location conditions and the required space
à
The substructure must ensure safe attachment of the drive.
à
The bottom edge of the element mounted at the lowest point (roller guide rail or link arm) must be mounted
at least 2 m above the floor.
X
Only use suitable means of fastening such as wall plugs, riveting nuts, etc.
X
Before installation of the drive check whether the door leaf is in a good mechanical state and can be opened
and closed easily.
X
Lay cables in accordance with the cable plan.
X
Check the planned type of installation on the leaf or frame profile (see section 5.3).
Check the space available
X
Maintain free space of at least 5 mm above the drive *)
X
Maintain free space of at least 19 mm between the upper row of holes and the ceiling.
min. 5 mm*
min. 19 mm
* For versions with smoke switch see the separate installation instructions for the minimum clearance. With
a clearance of 5-10 mm, the connector panel must be loosened during assembly of the drive, cf. chapter 7.6
Explanation of hinge clearance
There is a dotted line (3) on the mounting plate (2). The tape measure (1) can be fastened to the dotted line.
Explanation of screwing point
There are a total of 8 screwing points (5) with 2 drill holes each in the mounting plate (2), one inner and one outer
drill hole. The outer drill holes are to be preferred for fastening the mounting plate.
Fastening the mounting plate
à
Make sure the mounting plate is in the correct position, see directional arrow (4).
à Set at least one screw at each screwing point (5), preferably at the outer screwing points.
X
Screw the mounting plate (2) on using 8 screws.