GEZE IQ Series, Руководство пользователя, Страница: 19 / 88

EN 9
Operating modes IQ windowdrives
7 Operating modes
See A-III
Operating mode ventilation/alarm / control via alarm relay
à
For ventilation: Drive opens with ventilation speed till the
ventilation stroke
à
For alarm: Drive opens with alarm speed till the alarm
stroke
à
Different strokes are possible for ventilation and alarm.
See A-IV
Operating mode permanent alarm operation
Drive always opens with alarm speed till the
alarm stroke
See A-V and
A-VI
Operating mode ventilation without alarm-function
Drive always opens with ventilation speed till the
adjusted ventilation stroke .
In case of chain drives, the ventilation hub must be set to 300 mm. The ven-
tilation hub can be parameterised with the help of the commissioning case
and the programming device ST 220.
8 Commissioning
After applying the operating voltage for the first time, the drive can be
operated in the “OPEN” direction as well as in the “CLOSE” direction (24V A =
+24V, 24V B = GND). The drive automatically detects the closing position of the
window when closing for the first time and saves it. It must be ensured that
there is no hindrance at that time.
Should the drive reverse after reaching the closing position (drive opens
by approximately 15 mm), a commissioning run must be started. To do this,
proceed as follows:
X
Open window by at least 100 mm.
X
Actuate switch for closing the window (window begins to close).
X
Connect cables „B““ and „L“ for at least 5 seconds.
X
Thereafter, separate „B“ and „L“ link.
Now a new start-up drive is performed.
In the synchro-systems, the commissioning run is started along with all the
drives.
The drive can be parameterised with the aid of the start-up box (ID 139699)
and the programmer ST 220 (ID 087261). For more information on parame-
terisation, see the instructions of the start-up box.