Gewiss Chorus GW 90 834, Руководство пользователя

Страница: 23 / 64

Programming the inputs through the Easy base unit (code GW 90 831).
Each input to be programmed can be selected, at choice:
• by pressing the button or switch connected to the input: the corresponding channel will
be highlighted in the channel list in the "Application
→
New function" or "Application
→
Edit function" menu;
• directly from the list of channels of the “Application
→
New function” or “Application
→
Edit function” menus.
The functions can be created after the devices have been selected.
Refer to the Easy base unit documentation for further information on the programming
procedures.
After creating the desired function, it is possible to configure the device function
parameters from the "Application -> Parameters" menu.
The parameters available, in relation to the function created, are listed in the following
table.
The underlined value is the default value.
Configuration parameters (Easy)
23
Names of the functions on the Easy base unit
button toggle
edges edge management command
timer mode command ON with timer
(the time is set on the actuator)
scene scene management command
priority control send priority controls
dimming pushbutton dimming pushbutton management command
dimming dimming management command
blinds pushbutton blinds pushbutton management command
blinds blinds management command
wind sensor wind alarm management command
rain sensor rain alarm management command
heating mode thermal regulation commands (mode)
heating On/Off thermal regulation commands (enable/disable)
PROGRAMMING WITH THE EASY BASE UNIT
E
N
G
L
I
S
H