Gewa UP400, Руководство пользователя

Страница: 23 / 40

23
If you tap on the name of the combination in the upper part of the screen, a dialog for
naming the combination appears. If necessary, enter a new name here and confirm with
“OK“ or discard with “CANCEL“.
By default, the selected sounds (layers) of a combination sound simultaneously and over
the full tonal and dynamic range of the keyboard. To adjust this, press the settings button
next to the sound. This takes you to the layer editor.
In the upper part of the screen you can see which of the three layers is selected for editing.
By tapping this button repeatedly, you can cycle thrugh the layers. Next to it you can see
which sound is selected for the layer. You can also change the selected sound in this
view.
In the center area of the layer editor screen, you can specify the keyboard area where the
selected sound will be heard. To do this, press the “ learn “ button in the “ highest key “
line. If this is highlighted in blue, the piano waits for your input. Now play the highed note
on the keyboard that should trigger this sound. The piano recognizes the tone played and
automatically enters the key name.
Now press the “
learn “ button the “ lowest key “ line and set the lowest tone in the same
way.
The keyboard range of the selected layer is shown above the keyboard with a blue bar.
With the lines “
velocity max “ and “ velocity min “ you can define a velocity range in which
the selected sound should be played. This enables you for example to play a different
sound with a soft touch than with a hard touch.
With the “
Octave “ parameter you can move the octave position of the current layer. For
example, if you set it to two, the layer will sound two octaves higher than the notes actually
played on the keyboard. This is useful, for example, to play a surface sound with the left
hand that would sound way too low in the normal settings. The right hand can now be
moved normally to play a different sound to it.
OPERATING USE
SOUND ADJUSTMENT (EQ)