Getinge 2132A, Инструкция по эксплуатации, Страница: 14 / 40

AKRON STREAMLINE Model No.’s:- 2132A, 2132B, 2132C, 2142A, 2142B, 2142C, 2152A, 2152B, 2152C, 2162A,
2162B, 2162C
11
7. Troubleshooting – Electric Actuator
Symptom Possible cause Action
Actuator will not work Power disconnected
Fuse blown
Hand/footswitch
disconnected Ensure mains supply is connected
Contact your local Akron supplier
Check that the hand/foot switch is
fully inserted into the actuator
Actuator runs when Bar is not
pressed(Foot Bar Switch) Out of balance system Vent air tube by disconnecting
from actuator, then reconnect
If the problem persists consult your local AKRON Supplier
.
8. Maintenance
Check couch visually before use.
Carry out routine servicing every six months or more frequently if in heavy use.
Routine servicing or repair must only be performed by suitably qualified persons.
Examine the couch for any signs of damage. Make sure that all nuts, bolts and other fasteners
are tight. Do not over tighten as this may cause binding.
Upholstery fasteners should be checked, tightened or replaced if necessary.
Check section hinge pins to ensure that no pin protrudes.
Check gas strut controls, throughout the full range of movement for locking and assistance.
Check hydraulic couches for smooth operation and signs of leakage.
Examine the flexible cables for cuts, abrasions, kinking or other deterioration and replace if
necessary.
Ensure that the power supply connector plug is securely attached.
Check mains plug connections are tight and fuse (UK style, BS1363 plugs only) is correctly
rated (5A).
WARNING
Before commencing any maintenance activity, disconnect the couch from
the electrical supply. Plug acts as disconnect device.
WARNING
All electrical checks should be performed by a suitably qualified and
licensed electrician.
Only the GREEN/YELLOW wire is to be connected to the earth/ground
terminal of a three pin plug.