Operation
CONTROL PANEL
CONTROLS
Power Control
The power control turns the unit on and off.
When the plug is first plugged into a socket the machine will bleep and go into stand-by
mode. Pressing the “Power” button will turn the machine on. Pressing the “Power” button
again will put the machine back into stand-by mode.
Note:- After switching the unit off, wait 3 minutes before switching it on again.
Warning Light
This warning light will illuminate (Red) when the water tank within the machine is full and the
machine will stop. If after draining the tank, the warning light remains on, this could indicate
that there may be a fault with the machine. If this is the case, do not attempt to operate the
machine and call the service number.
Mode Control
The mode control has three settings
Cool Dehumidifier Fan
Repeated pressing of the mode button will select the modes in order as follows:-
Cool Mode - LED next to the “COOL” legend will illuminate green.
Dehumidifier Mode - LED next to DEHUMIDIFIER legend will illuminate orange.
Fan Mode - LED next to FAN legend will illuminate yellow.
Note:- In Cool and Fan mode, the fan speed can be set to High, Medium and Low. When
Dehumidifier mode is selected the fan speed is automatically set to Medium and cannot be
altered from this setting.
Cool Mode
In this mode the air is cooled and hot air is exhausted through the vent hose to outside the
room. Fan speed and temperature can be adjusted to suit the comfort level required.
Dehumidifier Mode
Air is dehumidified as it passes through the air conditioner and the damp warm air should be
exhausted by means of the vent hose to outside of the room.
Fan Mode
Air is cooled and circulated throughout the room. Note:- It is not necessary for the vent hose
to exhaust outside the room.
