BUTTON FUNCTIONS
POWER BUTTON
Used for switching the unit from “Standby” to “On” and from “On” to “Standby”.
TIMER BUTTON
With the machine on “Standby”, this can be used to set the time until the machine switches “On”.
With the machine “On”, this can be used to set the time until the machines switches back onto “Standby”.
HUMIDITY LEVEL SET BUTTON
Up (
▲
) and Down (
▼
) buttons used to set the required humidity level as shown by the Set Humidity Level Indicator.
FAN SPEED BUTTON
Used for selecting either High fan speed (
) or Low fan speed (
).
OPERATING INSTRUCTIONS
1. Ensure the plug on the dehumidifier is inserted fully into a working power socket. The machine will emit an audible
“Bleep” and will be in “Standby” mode.
2. It is important to ensure that the water tank is correctly positioned within the unit and that it is not full of water. If the
“Bucket Full” indicator is illuminated when the unit is plugged in for the first time, pull the water tank out of the unit
slightly and push it back into it’s proper position.
3. With the machine in Standby mode, pressing the Power Button will turn the machine on.
The internal fan will start up and repeated pressing of the Fan Speed button will switch the fan between high speed
and low speed. The fan speed is shown on the LED display,
= High speed and
= Low speed.
The LED display will also show the humidity level in the room and the room temperature.
The desired humidity level can be set using the up (
▲
) and down (
▼
) buttons and the set level will be shown on the
Set Humidity Level indicator.
4. If the surrounding humidity level is higher than the level set on the machine, the compressor within the machine will
start up and any moisture in the air drawn through the machine by the fan will form as water droplets on the
condenser within the machine. These water droplets will eventually collect in the water tank in the front of the
machine.
5. When the machine brings the humidity level in the room down to the level set on the machine, the compressor will
switch off but the fan will continue to run.
6. The compressor will continue to cycle on and off, keeping the surrounding humidity level close to the level set on
the machine.
7. Setting
the
Timer
The timer can be used to:-
a) Switch the machine ON after a predetermined time period of 1 to 12 hrs.
If this is required, the machine should be plugged into a power socket and in “Standby” mode.
Pressing the Timer button once will cause the timer display to flash “00”. Each time the timer button is pressed
whilst the display is flashing, will advance the time by one hour, i.e. “01”, “02”, “03” etc.
When the desired time (in hours) to “switch-on” is shown on the display do not press the timer button again.
The time set will then be permanently displayed on the machine and the machine will switch ON after the pre-
set time has elapsed.
b)
Switch the machine OFF after a predetermined time period of 1 to 12 hrs
.
If this is required, the machine should be plugged in and running.
Pressing the Timer button once will cause the timer display to flash “00”. Each time the timer button is pressed
whilst the display is flashing, will advance the time by one hour, i.e. “01”, “02”, “03” etc.
When the desired time (in hours) to “switch-off” is shown on the display do not press the timer button again.
The time set will then be permanently displayed on the machine and the machine will switch OFF after the pre-
set time has elapsed.
