GESTRA Gestramat CW 41, Оригинальная инструкция по установке

Страница: 28 / 40

28
Replacing the diaphragm actuator
The diaphragm actuator must be removed or
installed in the following cases:

To replace a faulty diaphragm actuator

To convert standard equipment to a diaphragm
actuator.
Replacing the diaphragm actuator
 Remove the two hex nuts (34) from the spindle
(17).
 Remove the lid (1) with the diaphragm actuator
(15), as described on page 25.

Take the double cone and spindle (17) out of the
body.

Remove the thermostats from the double cone,
as described on page 26.

Pull the spindle out of the double cone from
underneath.

Insert the new spindle into the double cone from
underneath.

Re-insert the thermostats in the double cone, as
described on page 26.
 Insert the double cone with spindle in the body.
 Fit the lid with diaphragm actuator to the body,
as described on page 27.
 Screw the two hex nuts (34) onto the spindle
(17).

Tighten the hex nuts hand-tight.
Converting standard equipment to diaphragm
actuator
To convert the equipment to work with a diaphragm
actuator, proceed as follows:
 Remove the lid (1), as described on page 25.

Take the double cone out of the body.

Take the thermostats out of the double cone, as
described on page 26.

Insert the spindle (17) into the double cone from
underneath.
 Re-insert the thermostats in the double cone, as
described on page 26.
 Insert the double cone with spindle in the body.
 Fit the lid with diaphragm actuator to the body,
as described on page 27.

Screw the two hex nuts (34) onto the spindle
(17).

Tighten the hex nuts hand-tight.
Installing the equipment following repairs
After repair work, re-install the equipment as
described on page 14.