Gerni Classic 120.2, Руководство пользователя

Страница: 8 / 20

8
4.3 Water connection An ordinary 1/2" garden
hose of min. 10 m and
max. 25 m will be suitable.
NOTE: Connection to the
public mains according to
regulations.
IMPORTANT! Only use
water without any im-
purities. If there is a risk
of running
sands in the
inlet water (i.e.
from your own well), an
additional fi lter should be
mounted.
1. Let the water run through
the water hose before
connecting it to the ma-
chine to prevent sand
and dirt from penetrating
the machine.
Note: Check that the fi l-
ter is fi tted in the water
inlet pipe and that it is
not clogged up.
2. Connect the water hose
to the water supply by
means of the quick con-
nector (inlet water, max.
pressure: 10 bar, max.
temperature: 40°C).
3. Turn on the water.
4.4 Start and stop of the
machine (when con-
nected to a water
supply)
The spray lance is affected
by a thrust during opera-
tion - therefore always hold
it fi rmly with both hands.
IMPORTANT: Point the
nozzle at the ground.
1. Check that the machine
is in upright position.
NOTE: Do not place the
machine in high grass!
2. Release the trigger lock.
3. Activate the trigger of
the spray gun and let the
water run until all air has
escaped from the water
hose.
4. Turn the start/stop
switch (1) to position"I".
5. Activate the trigger of the
spray gun.
Always adjust the distance
and thus the pressure of
the nozzle to the surface,
which is to be cleaned.
Do not cover the machine
during operation.
Note: If the
machine is left
or not used
for 5 minutes, it must be
switched off on the start/
stop switch "O" (1):
1. Turn the start/stop switch
(1) to position"O".
2. Disconnect the electrical
plug from the socket.
3. Shut off the water supply
and activate the trigger
to relieve the machine of
pressure.
4. Lock the spray gun.
When releasing the trigger
of the spray gun, the ma-
chine automatically stops.
The machine will start again
when you re-activate the
spray gun.