Gern Pro DAN0810, Инструкция по эксплуатации

Страница: 14 / 18

DAN0810
14
5. After the wheel was installed in the cutter, let it turn for a minute. Check fluttering of the cutting wheel,
heavy fluttering cause the cutting wheel to break. So you must install the clip again.
6. Before cutting, make sure the material has been fixed on the vise. According to the different shape if the
type material, the size of the diameter, the texture of the material, control the cutting speed.
REPLACE THE WHEEL

Replace cutting wheel when its outside diameter has defaced 1/3 approximately.

When replacing cutting wheel, be sure tool is disconnected from power supply and switch is in”OFF”
position.

Drawing wheel:
o
Push STOPPER PIN behind the protection cover, and you cannot revolve the wheel with hand.
And then, open the side cover.
o
An undoing hexagonal bolt enables to remove flange washer, outside flange, cutting wheel,
spacer, and inside flange in order.
PUTTING WHEEL
Clean spindle, inside flange and outside flange and do it by the manner revers to drawing wheel. (Fig 1)
Fig 1
1 GRINDING COVER 5 CUTTING DISC
2 SPINDLE 6 BACKING BRACKET
3 CLAMPING NUT 7 FLANGE WASHER
4 SPACER 8 HEXAGONAL BOLT
VISE CONTROLS

You can change the vise angle from - 30° to 45° by case. (Fig 2)
Fig 2
ADJUSTING THE VISE ANGLE
When controlling vise angle, after undoing hexagonal bolt, correspond angle divition to base line, and then
tighten the bolt.
SPANNER
STOPPER PIN
Fixed in 45°
Fixed in 30° Fixed in 15°
BASE LINE
VISE
ANGLE DIVISION
FIXED
SCREW