Gern Pro DAN0808, Инструкция по эксплуатации

Страница: 18 / 20

DAN0808
18
Checking and replacing the carbon brushes (fig. A)
The carbon brushes must be checked on a regular basis.

Remove the carbon brush holders (9) and clean the carbon brushes at the same time.

In case of wear, replace both carbon brushes at the same time.

Mount the carbon brush holder.

After mounting new carbon brushes, let the machine run at no load for 15 minutes.
Use only the correct type of carbon brushes.
Lubrication (fig. A)
After approximately 50 hours the machine must be lubricated.

Open the cover of the lubrication point (8) using the supplied key.

Apply an appropriate amount of grease to the mechanism.

Close the cover.
CLEANING AND MAINTENANCE
The machine does not require any special maintenance.

Regularly clean the ventilation slots.
TECHNICAL DATA
Product code DAN0808 (Z1C-DS-32TS-2)
Mains voltage 230V~
Mains frequency 50Hz
Power 1200W
Protection class II
Degree of Protection IP20
Speed (under load) 0-800/min
No. of strokes, under load 4000/min
Drilling capacity 32 mm (concrete)
13 mm (steel)
40 mm (wood)
Weight 5,6 kg
Level of sound pressure measured
sound pressure LpA = 96,4 dB(A)
acoustic power LwA = 107,4 dB(A)
Take appropriate measures for the protection of hearing.