German pool REF-365, Руководство пользователя, Страница: 9 / 21

P.17 P.16
8. Exchange the F: bottom hinge and F: upper hinge, then install them according to below steps, and
install the top hole cover and lower hole caps.
180°C
9. Remove the two fixed blocks of freezer door and rotate them for 180°, and install them onother side
of freezer door. The picture after completion is shown as above. (The picture above is for reference only.
The actual configuration will depend on the actual product or statement by the distributor.)
Installation
F:Bottom Hinge F:Upper Hinge
Fixed Block
Hole Cover Hole Cover Finish
Unlock
3 sec
(10 sec off)
S1. LED Display 8
° C
S2. LED Display 6
° C
S3. LED Display 4
° C
S4. LED Display 2
° C
Selection Button
Note:
When the fridge is turned on for the first time, the LED lights in the display screen of the temperature
selection zone will be on for 3 seconds and the refrigerator will automatically run at the Temperature of
4°C (S3).
Functions
Fault and Non-function Indication
Note: In case of a failure, the corresponding LED light blinks (see below table).
LED Light Blinks Fault Description
S1 Refrigerator Temperature Sensor
S2 Refrigerator Defrost Sensor
S3 Freezer Defrost Sensor
S4 Ambient Temperature Sensor
Power Off Function
First, press ( )for 3 seconds to unlock the selection button, then press ( ) for 10 seconds; when all
LED display lights are turned off, the refrigerator will enter the “power off” function mode, all functions
will be turned off. All the LED display lights will be off during the “power off” mode.
During the power off mode, can short press selection button ( )to exit the power off mode and the
refrigerator will return to its normal function.
• There are 4 temperature selections available with LED Display 8°C, 6°C, 4°C and 2°C. The current
temperature setting is indicated when one of the LED lights in the selection zone (S1-S2-S3-S4)
is on.
• To unlock the current temperature setting, press down and hold the selection button ( ) for 3
seconds, all the LED lights will be blinking for 2 seconds.
• Click ( ) to select temperature. The temperature lights of S1-S2-S3-S4 will take turn to be
turned on and off and the next one turned on after each click.
• The LED light of the selected temperature (S1 to S4) will be turned on permanently. This indicted
that the fridge is run on this selected temperature.
• If no selection is done in 30 seconds, the selection key ( ) is locked again.
Control Panel
Temperature Setting 7. Remove the freezer door, the bottom hinge and the hole caps.
F:Bottom Hinge Hole Caps