P.9
常見故障及處理
Troubleshooting
使用中如發現電磁爐操作上有問題，在送回本公司維修前請先依照下表進行檢查﹕
When you run into any problem operating this product, use the table below to troubleshoot the problem.
If the problem persists, contact our Repairs & Customer Service Centre.
故障現象 Phenomenon
檢查要點 Check-up Items
處理方法 Solution
接通電源，按機底電源開關，
再按“開/關”鍵，電磁爐無
反應。
Power is connected and Main
on/off switch is turned on,but the
induction cooker does not respond
when the on/off button is pressed.
•是否停電?
•府上的自動開關或
保險絲是否發生短路?
•插頭是否脫落或接觸不良?
•
Is there a power
shortage in your area?
•
Is there a short circuit in the
power source of your home?
•
Is the power plug too loose
or not connected well?
•電源恢復後再使用。
•檢查短路原因，排險後才使用。
•插牢或更換插孔後使用。
•
Try again after power supply resumes.
•
Find out the cause of short circuit
and eliminate it before switching on
the cooker again.
•
Re-connect the plug or replace the
power jack.
蜂鳴器斷續鳴響且鍋具不加
熱。
Buzzer beeps continuously and pan
is not heated.
•鍋具不適應?
•鍋具位置不合適?
•
Is the pan not suitable for
induction cooking?
•
Is the pan positioned properly?
•使用電磁爐適用之鍋具。
•將鍋具放置在電磁爐面板中心。
•
Use an appropriate pan.
•
Position the pan in the centre of
cook-top.
在正常運作時停止加熱。
Induction cooker stops heating
during normal operations.
•是否空鍋或溫度過高?
•吸氣口或排氣口是否堵塞?
•室溫太高?
•
Is the pan empty or cooking
temperature too high?
•
Are the air inlet and outlet
being blocked?
•
Is the surrounding temperature
too high?
•防止乾燒，降溫後自動繼續。
•待機件冷卻後才使用，並注意
保持內部通風。
•室溫降低後才使用。
•
Avoid operating cooker with an
empty pan. Let cooker cool down
before switching it on again.
•
Remove obstruction from the vent.
Let induction cooker cool down and
try again.
•
Try again after the room cools down.
保溫失控。
Temperature fluctuates.
•鍋底是否凹凸不平?
•
Is pan bottom not flat?
•更換平底鍋具後使用。
•
Replace pan with a flat-bottomed one.
* 以上為常見故障的判斷與檢查，只供用戶作參考之用。
* 如遇故障切勿自行修理，避免發生危險及對機件造成損害，請立即找專業技術人員或聯絡本公司作出適當維修。
* Above table enlists the most common problems regarding the operations of the product and their possible causes as well as suggested solutions.
It is strictly for users’ reference only.
* Should there be any product malfunction or breakdown, DO NOT repair it yourself. Contact our Repairs & Customer Service Centre or consult a
licensed technician immediately.
