注意事項
Safety Caution
清潔及保養
Care & Maintenance
- 請單獨使用13A以上的插座，切勿使用萬用插座或與
其他電器共用插座
- 請勿用水直接沖洗電磁爐，以免破壞電器絕緣性能
- 請勿於排氣口及吸氣口插入鐵絲、金屬等物件，以免
發生觸電危險
- 切勿讓鍋具猛烈撞擊陶瓷面板
- 電磁爐水平放置後，側面及背面距離牆壁必須預留最
少10 cm或以上，切勿堵塞出風口、將爐身鑲嵌或密封
- 請勿將電磁爐放置在煤氣爐、煤油爐等熱源附近使用
- 請勿將鐵片或其他鐵磁性材料直接放在陶瓷面板上加
熱，避免因高溫而產生灼傷危險
- 空鍋具請勿加熱過久，以免發生危險，鍋具溫度過高
時，電磁爐會自動停止加熱
- 切勿加熱罐頭等密封的東西，否則會因罐頭內氣體受
熱膨脹導致爆炸
- 不使用電磁爐時，請將電源插頭由插座拔出
-
Single 13A power jack must be used. Do not share
power jack with other appliances
-
Do not apply water directly on to induction cooker
-
Do not insert any wire or metal objects through air
inlet or venting outlet of the induction cooker
-
Please avoid collision between cook top panel
and cookware
-
A distance of at least 10 cm between the wall and
the sides of induction cooker must be reserved for
venting purposes
-
Do not place or use induction cooker near any
heat source
-
Do not heat up any metal plate or other magnetic
objects on the cook top
-
Do not heat empty cookware for an extended time.
Overheating of cookware will cause damages and
injuries
-
Do not heat up un-opened cans on the cook top. It
may cause explosion
-
When induction cooker is not in use, unplug the
power cord
-
Power plug must be disconnected before cleaning
-
Any stain or deposit on the cook top surface must be
cleaned off immediately before re-using
-
Cleaning must be done when cook top surface has
completely cooled down
-
If stain is minimal, wipe off with a dry cloth. If stain
remains, clean cook top with a moist sponge (soaked
with mild soap) and then wipe again with a clean cloth
-
To clean the body of induction cooker, wipe with a soft
clean cloth. If stain remains, clean with a moist
sponge (soaked with mild soap) and then wipe with a
clean cloth
-
Do not immerse induction cooker into water
-
Do not clean cook top with any rough cloth or
abrasive tool
-
Do not use organic solvents or any cleaning products
that contain chemicals such as Benzene
- 清潔前必須先拔下電源插頭
- 任何污垢必須即時清理
- 必須待爐面完全冷卻才進行清潔
- 清潔面板時，先以扭乾的濕布擦拭；若仍未能除掉污
漬，可用中性去污粉或洗潔精擦拭，然後再用濕布擦
拭即可
- 清潔電磁爐機身時，先用柔軟濕布擦拭﹔若有油污難
以清除時，用中性洗潔精擦拭後再用濕布擦拭乾淨
- 切勿用水直接沖洗或將機身浸入水中清洗
- 切勿使用堅硬之刷子刷洗爐面
- 切勿使用有機溶劑或苯等化學藥品擦拭電磁爐
常見故障及處理
Trouble Shooting
使用中如發現電磁爐操作上有問題，在送回本公司維修前請先依照下表進行檢查﹕
When you run into any problem operating this product, use the table below to troubleshoot the problem.
If the problem persists, contact our Repair & Customer Service Centre.
故障現象
檢查要點
處理方法
峰鳴器斷續鳴響且鍋具不加熱。
Buzzer beeps continuously and pan is
not heated.
在正常運作時停止加熱。
Induction cooker stops heating during
normal operations.
保溫失控。
Temperature fluctuates.
•鍋具不適應?
Is the pan not suitable for
induction cooking?
•鍋具位置不合適?
Is the pan positioned
properly?
•是否空鍋或溫度過高?
Is the pan empty or cooking
temperature too high?
•吸氣口或排氣口是否堵塞?
Are the air inlet and outlet
being blocked?
•室溫是否太高?
Is the surrounding tempera
ture too high?
•鍋底是否凹凸不平?
Is pan bottom not flat?
接通電源，按“開/關”鍵，電磁爐無
反應。
Power is connected, but the
induction cooker does not respond
when the On/Off button is pressed.
•是否停電?
Is there a power shortage in your
area?
•府上的自動開關或保險絲是否發
生短路?
Is there a short circuit in the
power source of your home?
•插頭是否脫落或接觸不良?
Is the power plug too loose or not
connected well?
電源恢復後再使用。
Try again after power supply resumes.
檢查短路原因，排險後才使用。
Find out the cause of short circuit and
eliminate it before switching on the cooker
again.
插牢或更換插孔後使用。
Re-connect the plug or replace the power
jack.
使用電磁爐適用之鍋具。
Use an appropriate pan.
將鍋具放置在電磁爐面板中心。
Position the pan in the centre of cook top.
防止乾燒，降溫後自動繼續。
Avoid operating cooker with an empty
pan. Let cooker cool down before
switching it on again
待機件冷卻後才使用，並注意保持內部
通風。
Remove obstruction from the vent. Let
induction cooker cool down and try again.
室溫降低後才使用。
Try again after the room cools down.
更換平底鍋具後使用。
Replace pan with a flat-bottomed one.
* 以上為常見故障的判斷與檢查，只供用戶作參考之用。
Above table enlists the most common problems regarding the operations of the product and their possible causes as well as suggested solutions.
It is strictly for users’ reference only.
* 如遇故障切勿自行修理，避免發生危險及對機件造成損害，請立即找專業技術人員或聯絡本公司作出適當維修。
Should there be any product malfunction or breakdown, DO NOT repair it yourself. Contact our Repair & Customer Service Centre or consult a licensed
technician immediately.
故障代碼
Code
E0
E3*
E4*
E5
故障代碼
Code
E6
E7
E8
E9
EA
故障說明
Error
無鍋具/鍋具不合適
No cookware / Inappropriate cookware
電壓過高
Voltage over-loaded
電壓過低
Voltage under-loaded
爐面感應器斷路
Open circuit of cook top sensor
故障說明
Error
爐面感應器短路
Short circuit of cook top sensor
爐面過熱
Cook top overheat
機內溫度感應器短路
Short circuit of internal temperature sensor
機內溫度感應器斷路
Open circuit of internal temperature sensor
機內溫度過高
Internal overheat
* E3及E4並不屬於機器故障，待電壓恢復後（187V—250V）即可使用。
E3 & E4 are not product errors. Operation can be resumed when power voltage returns to normal rating (187V - 250V).
P.08
