German pool CMC-101, Руководство пользователя

Страница: 12 / 28

P.12
5. Care and Maintenance
Decalcification
Drinking water varies according to region. The lime particles in hard drinking water are deposited
as residues in the machine and can block the piping and cause damage. To prevent this, be sure to
decalcify the machine every one and a half to two months.
Decalcification must be done correctly to prevent damage. So it is essential to follow these instructions.
Important Note:
– Never clean the machine with vinegar. This causes damage and makes your coffee taste bad.
– Damage caused by incorrect decalcification or failure to decalcify is not covered by the warranty
Caution: beware of hot water!
Procedures
1. Recommend to purchase commercially available decalcifier (decalcifying liquid), diluted according to
the manufacturer‘s instructions.
2. Make sure there is without capsule inside the machine.
3. Place a large bowl under the dispensing head to collect the decalcification diluted and lime residues.
4. Fill the water tank with water to maximum level mixed with decalcifying solution or lemon acid, make
sure the solution is dissolved completely.
5. Press the large cup button to run decalcifying water as you brew coffee normally, repeat for several
times to run out the entire tank water.
6. Repeat the process to run another tanks of water mixed with decalcifying solution.
7. Repeat the process to flush out the intern circuit with a tank of fresh water (without the decalcifying
solution) to clean the internal circuit completely.
Using the pump
Before initial use or after long periods of time of not using (e.g. holidays) the machine may have difficulty
pumping water. The following short procedure can regulate the water circulation within the coffee
maker, by using the pump and pipe to inject water into the coffee maker manually prior to turning on the
coffee machine for its first refill.
1. Insert the pipe into
the water opening.
After the above steps, the machine will be able to pump water out normally.
*If necessary repeat these steps 2 or 3 times.
2. Pour small amounts of
water into the pipe.
3. Push down on the pump to
inject water from the pipe
into the appliance. The
internal pipeline will be filled
with water removing any
excess air.