P.6
Safety Precautions
The risk of causing danger to personnel, serious injuries, and major property losses is strictly prohibited.
01. To protect against risk of electrical leakage and damage to components of the unit, do not immerse the
blender base in water or any other liquids, or rinse it under water or other liquids.
02. Do not touch any detachable parts such as blade or motor to avoid injury or damage to the product.
03. Store the appliance and accessory parts out of the reach of children. This appliance shall not be used
or played by persons (including children) with decreased physical, sensory or mental abilities or lack of
experience and/or knowledge.
04. It is forbidden to process overheated food (≥60°C) and liquid into the cup so as to avoid cracking or
splashing.
05. Do not put the appliance in the vicinity of high temperature, strong magnetic, inflammable and combustible
materials (such as natural gas, biogas, etc.) to avoid damage and malfunction of its parts and avoid fire.
06. The appliance is intended for household use only and should be operated in accordance with the instructions
in this manual. Do not use the appliance outdoors or for other than intended purpose.
07. Never run the unit empty (without materials in the bottle) or overload.
01. The voltage of the appliance is 220V~50HZ. Check it matches the local voltage before powering on. Higher or
lower voltage may affect the product performance or damage the electrical components. A pressure regulator
is recommended for the normal operation of the machine.
02. To avoid leakage or accidental start-up, be sure to unplug the power plug before removing, installing,
adjusting or cleaning any part of the product.
03. This product belongs to Y connection. Please check the power cord, plug and other components are well
before use. To avoid danger, if any damage is found, please stop using it and contact our customer service
center. Do not disassemble the unit without authorization to avoid danger.
04. Before powering on, make sure the switch is off and the detachable components are installed in right place.
05. Before installing the blade assembly on the end of the jar, do not forget to put the seal ring on the blade
assembly, otherwise it will cause leakage.
06. The jar must be securely fastened to the blade assembly to prevent the product from leaking during
operation and the blade assembly from falling off and other abnormalities.
07. Securely fasten the jar to the blade assembly before installing it on the blender base. Do not install the blade
assembly separately on the blender base.
08. If the product stops working during operation, it may be caused by the temperature control of the motor.
Please turn off, disconnect the power supply, and use it after cooling down for 20-30 minutes.
09. Please cut the ingredients to a diameter of about 2cm to prevent the blade from getting stuck and causing
the motor to smoke.
Be aware of the risks that may result in personal injury or damage to the item.
CAUTION
CAUTION
Prohibit
Prohibit
