German Light Products JDC1, Руководство пользователя

Страница: 6 / 72

www.glp.de
6 JDC1
User Manual Rev. 3.0
•
Refer any service operation not described in this manual and refer all repairs to a
technician authorized by GLP.
•
The light source in this product may not be changed by the end user.
•
Read and follow the user documentation for all additional equipment.
Electrical safety
•
Do not allow the product to come into contact with water or moisture.
•
Use only a source of AC mains power that complies with local building and
electrical codes and has both overload and ground fault (earth fault) protection.
• Ensure that the product is electrically connected to ground (earth).
•
Disconnect the product from AC mains power before carrying out any installation or
maintenance work and when the product is not in use.
• Disconnect the product from power immediately if the power plug or any seal,
cover, cable, or other component is damaged, defective, deformed, wet or
showing signs of overheating. Do not reapply power until the product has been
repaired and made safe by a technician authorized by GLP.
•
Before using the product, check that all power distribution equipment and cables
are in perfect condition and rated for the electrical requirements of all connected
devices.
•
Use only Neutrik PowerCON TRUE1 cable connectors for AC mains power input at
the product’s power connector.
• Use minimum 14 AWG or 1.5 mm
2
power input and relay cables that are minimum
16 A rated and temperature-rated to suit the application. In the USA and Canada
the cables must be UL-listed, type SJT or equivalent. In the EU the cables must be
type H05VV-F or equivalent.
•
The supplied power input cable is rated as follows:
-
US power cable: 16 A, 14 AWG, UL listed, E304117, SJT, 4.9 ft.
-
EU power cable: 16 A, 1.5 mm², H05VV-F, 1.5 m
•
If a fuse blows, replace it with one of the original type and rating only. If new fuses
blow, disconnect the product from power and send it to a technician authorized by
GLP for repair.