R
R
R
-
-
-
G
G
G
-
-
-
B
B
B
1.1
Safety Instructions
The
I
I
M
M
P
P
R
R
E
E
S
S
S
S
I
I
O
O
N
N
X
X
L
L
is a High-Tech Product. To guarantee a smooth
operation, it is necessary to respect the following rules.
The manufacturer of this device will not take responsibility of damages
through any disregard of the information in this manual. Warranty claims also
will be cancelled in case the system casing is opened.
1. Make sure before putting the system into operation, that the fan and the air inlets are clean
and not blocked by anything.
2. It must be assured that the system-head can rotate unhindered throughout his complete
rotating range. A safety distance of at least 0.5 m to any easily inflammable material (e.g.
decoration material) must be adhered.
3.
Attention!
Don’t touch the device during the operation. This can cause injuries or
damages.
4. Only connect one cable to the DMX-Out/Input at a time!
5.
Attention!
The Tilt-Lock shall only be used to secure the head of the unit during transport
– or during repair of the fixture.
Never
lift or carry the fixture by holding its head when the
Tilt-Lock is in position. Otherwise the Tilt-Lock may become dysfunctional.
6.
The system doesn’t contain any maintainable parts. Don’t open it!
7. It is necessary to wait at least 15 minutes after disconnecting the AC before changing the
optical carrier. Pay attention to possibly hot parts of the system.
-- Danger of BURNING --
8.
Never look directly into the beam of light or one of the LEDs.
Never use optical
apertures with a distance less than 0.5 m to observe the beam of light.
LED Class 2M.
You'll risk a serious injury of your eyes and in particular of your retina.
Attention:
LED Class 2M can cause injuries of your eyes even
without optical instruments in front of them or within a distance
of less than 0.5m and short exposure time.
Hence: Avoid direct radiation of your eyes!
9. To allow a secure operation, follow also the Installation guide described in chapter 2.
Operating the
I
I
M
M
P
P
R
R
E
E
S
S
S
S
I
I
O
O
N
N
X
X
L
L
without suitable safety aids like Safety cables or
clamps/hooks can increase the risk of an accident.
10. Repair-, maintenance- and installation work shall be done by qualified or GLP certified staff
only. You need to pay attention to the common rules of technology that are not explicit
mentioned in this manual.
11. Use only original spare parts. Any structural modification on the system will terminate all
warranty claims.
GLP
German Light Products GmbH
(Manual Version 1. / from Software Version 1.09/0.3)
5
