4. Remove the (2) phillips screws located on each
side of the bulb holder and remove the filter.
5. Lift bulb holder from cylinder. Do not touch bulb. If
cleaning, insert a soft, dry cloth into cylinder and
remove. Repeat if necessary. Do not touch bulb with
bare hands. Fingerprints may result in reduced
performance unless they are removed with an alcohol
pad. Use a soft cloth as a barrier against contact.
6. If NOT replacing the bulb for the first time jump to
step 7. If replacing the bulb for the first time, flip
bulb holder over so light bulb faces up. There will
be a spring located between the bulb cylinders.
Squeeze spring tightly towards bulb and pull out of
holder and through bulb. Discard spring. Spring is
used for shipping purposes only and does not need
to be replaced.
E-6
E-7
7. Grasp the metal collar on the bulb and pull firmly
until bulb unplugs from the bulb holder. When
inserting new bulb, make sure the bulb snaps and
is locked firmly in place. Reassemble by reversing
steps 1-7.
TROUBLESHOOTING GUIDE
PROBLEM
SOLUTION
Unit doesn’t operate.
Check that unit is plugged in. Call customer
service 1-866-603-5900.
Fan runs but no light.
Bulb burnt out. See Replacing UV-C Bulb section
of manual.
Light flickers.
Bulb burnt out. See Replacing UV-C Bulb section
of manual.
Low air flow.
Check fan setting knob, turn clockwise to high.
Replace filter. See Replacing UV-C Bulb and Filter
section of manual.
EV9102REV1208: Air Sanitizer Manual 3L 12/15/08 2:30 PM Page 4
