GEPRC Cygnet 3, Быстрый старт

Страница: 16 / 18

Cygnet Manual
- 16 -
Cygnet
7
、
Set up the VTX
1. Set the Channel. In standby mode, press and hold the key for 3 seconds, the blue LED flashes,
short press, change the channel value.Every time 1 press will change the CH, followed by 1CH to
8CH cycles.
2. Set the Band. In the channel setting mode, press and hold the key for 3 seconds, the green LED
flashes, briefly presses, changes the frequency group value.Every time 1 press will change the
band, and then the A band to F band loop.
3. Set the Power.In the band setting mode, press and hold the key for 3 seconds, the red LED flashes,
short press, change the output power value.Every time 1 press will change the power, followed by
25mW / 100mW / 200mW cycle.
4. frequency table：
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8
Band A 5865 5845 5825 5805 5785 5765 5745 5725
Band B 5733 5752 5771 5790 5809 5828 5847 5866
Band E 5705 5685 5665 5645 5885 5905 5925 5945
Band F 5740 5760 5780 5800 5820 5840 5860 5880
Band H 5362 5400 5436 5473 5510 5547 5584 5620
Band R 5658 5695 5732 5769 5806 5843 5880 5917
5. VTX LED display
5.1. BLUE: Frequency channel display, the time of flash represents 1 to 8 channels, 1 = CH1,2 = CH2, ...
8 = CH8.
5.2. GREE: Frequency Band display, the number of flashes represents the frequency group from A to
R, 1=A, 2=B……6=R
5.3. RED: Power output display, 1 = 25mW, 2 = 100mW, 3 = 200mW.
How to turn VTX on or off: In the working state, quickly double-click the set button, RED / GREEN / BLUE sync