Installing Camera Module
Insert the video cable through the screw
cap and the inside rubber of the cap.
7.
Rubber
Screw Cap
Attach the video cable to the BNC
connector and plug it into the “VIDEO OUT”
jack.
8.
Adjust the length of the video cable and
seal it with the waterproof tape.
9.
Tightly screw the cap.
10.
Loosen the screw cap on the left, insert
the power cable through the screw cap
and the inside rubber.
11.
Remove the terminal block. Plug black
and white wires of the power cable to the
terminal block. Reinsert the terminal block
onto the camera. The white wire is
required to connect to the positive pin (+)
on the camera and the black wire to the
negative pin (-).
12.
VIDEO OUT
Jack
Adjust the length of the cable, seal it with
the waterproof tape, and then tightly
screw the cap (see Steps 9 and 10 for the
pictures).
13.
Push the sun shield forward to align with
the back of camera enclosure.
1.
Slightly lift the camera module and slide it
out completely.
4.
Remove the foam.
5.
2.
Pull out the camera module.
Sun Shield
Camera Enclosure Back
Camera Module
Completely slide the camera
module out
Loosen the set screws on the back of the
camera enclosure.
3.
Loosen the screw cap on the right.
6.