Bullet Camera (Part II)
33
2
C. Re-install the cable seal. Make sure it is installed tightly to
waterproof the camera.
8.
Thread wires into the camera.
A. Disintegrate the removed conduit connector. You should have 4
parts:
1
2
3
4
Figure 2-13
B. Remove the terminal block from the supplied power adapter.
C. Optionally thread audio wires, adapter wires, and I/O wires
through the conduit converter and then through part 1, 2, 3, and
4 of the conduit connector.
Tip:
To make the threading easier, it is advised to thread the wires in the
order described here.