Instruction Manual COMPACT Arm
Arms and friction joints: The Arm consists of three
joints. The inner carrying arm is executed in
45x45 mm aluminium profile, supplied with
adjustable fittings, where the power of the spring
may be adjusted. Inside this profile, the middle
35x35 mm ALU-profile is moved by means of
journal bearings. The outer joint, a 25x25 mm
aluminium profile, is moved by means of journal
bearings in the middle profile.
2.0 Installation
The COMPACT Arm is supplied partly assembled.
Depending on model, it may consist of one
carrying arm, one funnel, and one set of hose with
clamp and rubber band. As standard, the Arm is
prepared for ceiling mounting, however, in most
cases it will be mounted on a wall by means of a
wall bracket (to be ordered separately).
Before mounting the Arm, please make sure that
the optimum working area is selected. Is there
space enough for the satisfactory utilisation of the
Arm? What about connection possibilities for
piping and automatics? The optimum installation
height is then to be selected in accordance with
the table below:
Recommended installation height COMPACT Arm:
1-2 m
1800 mm
1.5-3 m
2000 mm
3.0 to 7.0 m (incl. extension arm)
2500 mm
Procedure:
1. For wall mounting, attach the wall bracket
firmly to the wall by means of 4 off 10 mm
bolts (when using the extension arm, please
fix this bracket first – refer to item 2.1).
2.
Then the ceiling bracket is mounted, either in
the ceiling or in the wall bracket (refer to the
drawing below). The bracket is fixed via
attaching the 4 off 8 mm bolts with 4 off
bevel-edged washers and lock nuts.
3. Then the Arm looks like the one shown on
the picture below. The functionality of the
Arm is tested and the inner joint is tightened
up, if necessary.
4. The outer joint for the funnel is tested and
tightened up, if necessary. The funnel must
be self-retaining in all positions.
Ø160 Wall bracket
Ø200 Wall bracket
Ø160 Ceiling bracket
Ø200 Ceiling bracket
