Geotech ET WLM, Инструкция по установке и эксплуатации

Страница: 14 / 24

12
Section 5: System Troubleshooting
Problem: No signal (audible or visible) when unit is turned on.
Solutions:

The battery is discharged. Check or change battery (Section 4).

The circuit is malfunctioning. Contact Geotech Service.
Problem: No indication of water.
Solutions:

The conductive contact is dirty. Clean the contact (Section 4).

There is an open connection in the tape. Replace tape and/or probe.

The circuit is malfunctioning. Contact Geotech Service.
Problem: The signal (audible or visible) is intermittent.
Solutions:

There is an open connection in the tape. Replace tape and/or probe.

There is a loose connection in the circuit or the probe. Repair the
connection.
Problem : The signal (audible or visible) is continuous when not in water.
Solutions:

Make sure the meter is in standard mode. Place the mode switch to the
“Right“, for normal operation.

The conductive contact is dirty (causing bridging). Clean the contact
(Section 4).

There is a short in the tape and/or probe. Replace tape and/or probe.

The circuit is malfunctioning. Contact Geotech Service.
Problem: Controller shuts down automatically when ET WLM has draw down
feature connected.
Solutions:

ET WLM is in standard ET WLM mode. Lower the probe until it contacts
the water level and switch to draw down mode.

ET WLM is in draw down mode, but water level dropped below probe.Wait
for well to recharge and make contact with probe, or lower probe to contact
water.
For technical assistance, call Geotech Environmental Equipment at 1-303-320-
4764 or 1-800-833-7958