GEOSATpro DVBS2, Руководство пользователя и инструкция по установке

Страница: 18 / 73

B. Gohl
© GEOSAT pro
16
Roof Mount Wall Mount
The GEOSATpro 90cm dish assembly includes a heavy duty universal wall / roof
post mount. This mount can be attached at almost any angle and provides a stable
secure mount even in high wind regions if properly attached. The tripod legs
MUST
be installed. The universal post will fail under moderate wind load if the
tripod legs have not been installed to support the larger wind load area of a 36”
dish. The dish and mount are designed to remain operational in winds up to 80+
mph and survive wind gusts over 110+ mph.
Before assembling a metal dish it is
Extremely Important
to verify that the
reflector was not warped or bent during shipping. Failure to check for dish warping
or damage could lead to many frustrating hours of trying to locate the satellite.
This simple test may be the most important step in a successful installation!
Bad - Warped Reflector
Good - Reflector
Find a perfectly flat surface such as a garage cement floor and lay the reflector
face down. Are the edges of the reflector laying perfectly flat? If any area of the
edge is raised by even an 1/8th of an inch reception of the satellite signal will be
affected!
If you cannot find a perfectly flat surface or if the
dish is already installed, perform the string test.
Tape a string horizontally from edge to edge
across the center of the dish. Tape a second string
vertically from top to bottom on the edges of the
dish.
If the strings do not lightly touch in the center,
the dish is warped and it must be corrected before
aiming the dish.
Dish Assembly