6
•
Start the motor by pressing the desired speed or function button. Select the speed that
best suits your task
(see the Speed Chart on page 9 for more information)
. The power
LED will flash slowly while the blender is in use.
•
When done, press the Pulse/Stop button to stop the motor.
CAUTION: Wait until the blades come to a complete stop before proceeding further!
•
Lift the jug upward to remove it from the motor unit.
•
Switch the blender off by pressing the Power on/off button and disconnect the plug from
the wall power outlet.
PREPARE THE BOTTLE FOR USE
NOTE: Prior to use, the blender bottle should be dismantled and washed as instructed
in the “CARE AND CLEANING” section of this manual. Following cleaning:
•
Place the blender bottle on a flat surface with the open end facing up.
CAUTION: Do not place hot ingredients into the bottle. For your own safety we
recommend you do not process ingredients above 40C.
Do not add hot liquid (over 40°C),
as it may be ejected due to sudden steaming. Do not fill past the 600mL mark.
•
Place ingredients to be blended into the bottle, solids first, then any liquids.
CAUTION: Handle the sharp blade assembly with care.
•
Fasten the blade assembly on the open end of the blender bottle and turn it clockwise
until it is tight.
•
Uncoil the power cord from the storage area under the motor unit.
•
Sit the motor unit on a stable, level, dry surface.
•
Turn the bottle upside down and place it on the motor unit ensuring it is correctly seated
with the tabs of the blade assembly aligned with the recesses in the motor unit.
•
Turn the bottle clockwise to lock it into place.
•
Press the Power on/off button. The blue power LED will glow steadily to signify the
blender is in standby mode (the blender will power-off in 60 seconds if no buttons are
pressed).
CAUTION: Hold the bottle!
•
Before starting the motor, place and leave your hand on top of the bottle to prevent the
possibility of the bottle being dislodged by the sudden movement of ingredients when the
motor starts.
•
Start the motor by pressing the desired speed or function button. Select the speed that
best suits your task
(see the Speed Chart on page 9 for more information)
. The power
LED will flash slowly while the blender is in use.
•
When done, press the Pulse/Stop button to stop the motor.
CAUTION: Wait until the blades come to a complete stop before proceeding further!
CAUTION: Ensure the bottle does not unscrew from the blade assembly when removing
it from the motor unit. If loose, turn the bottle clockwise again to tighten, then turn anti-
clockwise to remove the bottle and blade assembly from the motor unit.
•
Turn the bottle anti-clockwise and lift upwards to disengage it from the motor unit.
•
Stand the bottle on a flat surface with the blade assembly end facing upwards.
