13
12
9.
Note: Lifting and positioning the Lid and Grill Assembly requires two peo-
ple.
Carefully lift the Lid and Grill assembly into place on top of the cart, taking
care not to pinch ignitor lead from right burner. Raise the Lid, align the
mounting holes inside the grill body with the mounting holes on the left and
right Side Panels of the cart assembly. Secure in place with a Long Bolt,
Lock Washer and Flat Washer at all four locations, however, do not tighten
until after step 13.
Side Frame
Mounting Holes
Grill Body
Mounting
Holes
Assembly Instructions (cont)
6.
Attach the Upper Frame
Support to the front of the
cart, as shown (with
screw holes on top).
Secure both ends in place
with a Short Bolt, Lock
Washer and Flat Washer.
Attach the Lower Frame
Support to the cart by
inserting the extension
knobs into the mounting
holes. Slide the Lower
Frame Support down to
lock it in place. Pin on
Support must meet with
keyhole slot in side rails.
Secure the Door Stop in
place with a Long Bolt,
Lock Washer and Flat
Washer as shown.
7.
On the bottom hinge-side
of each door is a pin that
extends about 1/2". The
top hinge-side contains a
mounting hole. The Upper
Frame Support contains a
spring-loaded pin, one at
each end of the Support.
The Base Panel contains
mounting holes designed
to accept the pins on the
lower end of the Doors.
Attach the right door by
Inserting the hinge pin at
the bottom of the Door
into the mounting hole in
the Base Panel. Raise the
spring-loaded pin in the
Upper Frame Support , align the mounting hole in the top of the Door and
release the spring-loaded pin to secure the Door in place. Repeat this pro-
cedure with the left Door.
8.
At this point, securely tighten all the hardware. The cart is now fully assem-
bled and ready to accept the Lid and Grill Assembly.
Upper Frame
Support
Lower Frame Support
Spring
Loaded Pin
Mounting
Hole
Mounting
Hole
Pin
Door Stop
Long Bolt,
Lock Washer
and Flat
Washer
GR-GBQ440_IB_1-4-04 4/1/04 3:28 PM Page 23