George Foreman 2531CS-0025, Инструкция по безопасности и эксплуатации

Страница: 11 / 20

LIGHTING YOUR BBQ
USING THE AUTOMATIC IGNITION
Caution : The lid must be open when lighting the BBQ
Do not stand with your face directly over the gas grill when lighting it.
1. Ensure the dial is in the “OFF” position.
2. Turn the gas cylinder valve to the “ON” position at the regulator.
3. To create a spark, press the control dial (A) into the BBQ and hold
in position for 3-5 second to allow the gas to flow.
Then turn the control dial anticlockwise to “HIGH” (B).
This will create a spark to the burner lighting tube (C) and this
should make a “snap” sound and produce an orange flame from
the burner lighting tube at the left side of the burner (D)
4. Continue to hold the control dial in position for a further 2 seconds
to allow the gas to flow (E) and ensure ignition.
On the “HIGH” setting, the flame should be approximately 12 -20mm
high with an orange flame.
Turn the gas control fully anticlockwise for the minimum heat setting
Warning : If the burner still does not light ,turn the burner control
knob to” OFF” and wait 5 minutes to let the gas clear before lighting
again.
Warning: If the burner goes out while the grill is in operation, turn the
control dial to the “OFF” position. Open the lid and wait 5 minutes
before attempting to relight the BBQ.
11