Geokon 4415 Скачать руководство пользователя страница 6

Страница: 6 / 10

2. INSTALLATION INSTRUCTIONS

2.1.1 Assembling the Spacer Block into the Crackmeter

NOTE:

This section is required for 50 mm range crackmeters only (model 4415-5). For

the 12.5 mm and 25 mm range crackmeters (models 4415-1 & 4415-3) the spacer block is

installed at the factory.

Referring to Figure 1, install the spacer block between the two pieces of the crack meter

as follows:

With the inside of the three-sided cube facing you, slide the right side of the cube into

the gap between the spacer block and the metal bar attached to it until the edge of the

cube is pressed against the spacer block.

Next, slide the spacer block downward until it is resting flat against the bottom of the

cube,

Hand tighten the two cap screws that do not have washers installed, until they are in

firm contact with the back side of the cube.

Mount the rectangular bar portion of the crack meter on the spacer block using a cap

screw and washer as shown in Figure 1.

Continue the installation by following the steps in Section 2.1.2

Figure 1 - 4415-5 Crackmeter with Spacer Block Installed

Содержание 4415

Страница 1: ...ny means without the written consent of Geokon The information contained herein is believed to be accurate and reliable However Geokon assumes no responsibility for errors omissions or misinterpretation The information herein is subject to change without notification Copyright 2015 2019 by Geokon Doc Rev C 8 8 19 ...

Страница 2: ......

Страница 4: ...meter 3 3 TAKING READINGS 4 3 3 1 Taking Readings with a Dial Indicator 4 3 3 2 Taking Readings with a Depth Micrometer 5 APPENDIX A SPECIFICATIONS 6 FIGURES FIGURE 1 4415 5 CRACKMETER WITH SPACER BLOCK INSTALLED 2 FIGURE 2 READING LOCATIONS FOR MODELS 4415 1 4415 3 4 FIGURE 3 READING LOCATIONS FOR MODEL 4415 5 4 TABLES TABLE 1 SPECIFICATIONS 6 ...

Страница 10: ...n each X Y Z axis 4415 1 0 12 5 mm 4415 3 0 25 mm 4415 5 0 50 mm Material Stainless steel Anchors 4 rebar Anchor Dimensions Dia Length 12 mm 150 mm TYPICAL DEPTH MICROMETER DIAL GAUGE Range 50 150 mm Resolution 0 01 mm Accuracy 0 05 mm Table 1 Specifications ...