JETPRESS 14
Clamp
Base
Plug Socket
Heating Light
Silicone Pad
Pressure Knob
On/Off Switch
Start Up
1.
Connect power cord to the press. Pass the cord down through the
cord clip (the clip may need to be temporarily removed). Plug the cord into the
plug socket in the back of the control console, and then into power receptacle.
2.
Turn the power on by flipping the On/Off Switch on.
3.
Turn the Temperature Knob to the right (clockwise) and wait for
the press to come up to heat. The Heating Light will be lit while heating.
When the thermometer indicates the desired temperature, turn the temperature
knob back to the left (counter-clockwise) slowly until the red heating light turns
off. The Heating light will continually cycle on and off to regulate your tempera-
ture setting afterwards, and the machine may be pressed whether lit or not.
Important Notes
1.
Always leave Heat Platen in Up/Unclamped position when not pressing. Pro-
longed contact with the silicone pad will decrease the life of the pad.
2.
Do not leave press On unattended, or for extremely long periods of time.
3.
Do not let power cord come in contact with heat platen.
4.
Silicone pad may be slightly larger than heat platen, or may expand due to heat. This is normal.
5.
Heat platen may pivot slightly back and forth rotationally. This is due to movement allowance
within the clamp assembly, and is normal.
Thermostat Knob
Thermometer
Rear Guide
Gas Spring
Содержание JetPress 14
Страница 1: ...Ver 4 00 JETPRESS 14...
