loads. This LED will flash for a brief time at turn-on and turn-off, indication that
the protection circuits are operating.
Clip/Limit LED- This indicates the output status of the power amp. A limit switch
is located on the back of the unit. In the DEFEAT position, this LED indicates
clipping of the main amplifier. This shows true clipping which may occur before
you will be able to hear it. Excessive clipping can damage loudspeakers!!
With the limiter switch in the ACTIVE position this LED indicates operation of the
amplifiers limiters to prevent clipping. The limiters used are a soft-clip device and
are not intended to prevent clipping (and unwanted signal pumping), but intended
to extend headroom of the amplifiers by approximately 6db, while reducing the
audible effects of amplifier clipping.
Power LED- This indicates that the amplifier is on and the low voltage regulated
power supplies are active.
REAR PANEL
Power Inlet socket-This amplifier is supplied with a detachable power cord. When
connecting this amplifier to an AC outlet, always plug the cord into the power inlet
socket first before plugging the unit into a power source.
Speaker Outputs-2 standard 1/4” jacks are wired for parallel outputs and 1
Neutrik 4 pin connector are supplied as standard. Minimum impedance is 4
ohms.
Limit Switch-This switch turns the internal limiter on and off. Ground Lift Switch-
This switch lifts the ground on the XLR Direct Out.
Heatsink- This extrusion along with an internal cooling fan provides ample
dissipation of heat from the output devices. You may feel air coming out from
under the heatsink. An air-flow chimney has been designed into the chassis to
allow for air movement across and up the heat sink
. It is very important not to
restrict the air-flow to the side mounted fan.
Fuse Holder- Always replace with same type of fuse.
ATTENTION:
•
Always make sure that you are using a safe ground receptacle for the
specific operation for the voltage rated, labeled on the rear of the amplifier.
All US models are rated at 120 V AC 60Hz.
•
Always plug the AC power cord into the rear amp receptacle before
plugging the cord into a power supply.
•
Always use caution against possible hearing loss when operating this unit.
WARRANTY:
The electronics section of the Series 2 amplifier are warrantied to be free from
defects in materials and workmanship for 2 years. Items not covered are
damage from shipping, miss-use, accident, modification, abuse or neglect. See
your warranty card for details. All warranty service must be performed by an
authorized Genz Benz repair center.
