Call Handling
Screener
Control
OFF Button
Pressing the OFF button on the screener surface
will disconnect a call. You do not need to place
the handset in the cradle to disconnect calls.
AIR Button
The screener cannot place a call on the air unless
Screener Air Control is enabled in setup (see
Manual page 32). If enabled, the screener can
send a call from the handset to air by pressing the
AIR button. If a previously screened call is hold-
ing, it can be placed on air by pressing AIR and
then the LINE button. To put an on-air call on hold,
press AIR and then the LINE button.
NEXT Button
NEXT is used for selecting calls which have been
placed on hold. When pressed, the NEXT button
will select the line of the oldest holding call.
SCRN Button
When SCRN is pressed, the call on the handset
will be placed on hold as a screened call. The
LINE LED will flash red. These calls are made
available to the studio control surfaces as
screened-holding calls.
All other functions are the same as for a studio
control surface, except REC, MUTE, CONF, and
VIP which have no function on the screener con-
trol surface.
Perfect Communication through Technology,
Service, and Education.:
Gentner Communications Corporation
1825 West Research Way
Salt Lake City, UT 84119
Phone: 1.800.283.5936 / +1.801.974.3760
Fax:
1.801.977.0087
Web:
www.gentner.com
Document Part No. 800-003-003 (Rev. 3.0)
Call Handling
Studio Control
Off-Air
Answering a Call
Pick up the handset and press the line button of
the ringing (green flashing) line. The call will be
connected off-air. Each time a new line is taken,
the previous line will be disconnected, unless you
are in Previous Hold mode (see Manual page 36).
Making a Call
Pick up the handset and press the line button of
any line not in use. Dial normally.
Hanging Up a Call
Replace the handset in the cradle.
Placing a Call On Hold
While the call is on the handset (out of the cradle)
press the HOLD button.
Taking a Call Off Hold
To take a call off hold and talk on the handset,
press any line button with the
handset
off-hook.
You can also press the NEXT button to take the
oldest holding call.
Transferring a Call from the
Handset to Air
With the call on the handset, press the AIR button.
The line LED will change from a green glow to a
red glow, indicating that the call is on-air. For
Screener Air Control, see Manual page 43.
